Heath Zenith 598-1127-03 Door User Manual


  Open as PDF
of 24
 
-4-
598-1127-03
Troubleshooting
A. Chime does not sound:
• Makesurepushbuttonandchimecodesarethesame(seeFigure7).
• Checkorientationofpushbuttonandchimebatteries.(Seediagraminside
push button and chime for correct battery orientation.)
• Checkchargeofpushbuttonandchimebatteries,replaceifnecessary.
Chimeisreceiving
interferencefromanotherwirelessdevice;changethecodesetting(see
Code Settingbelow).

• Donotmountchimeorpushbuttononmetalornearmetalstuds.This
reducesthetransmitterrange.Use1/4"to1/2"(6to13mm)woodshims
to move chime or push button off metal surface.
• Concreteoorsmayreducerange.Movechimeawayfromoor.
• Trylocatingchimeclosertopushbutton.
D. Code Setting:
It is recommended to only change one code position at a time and then check
to see if system is functioning properly.
1.Openthecasesandlocatethejumpersonboththepushbuttonandchime
(seeFigure7).
2.Thepushbuttonhasthreedifferentjumperlocationsandthechimehassix
differentjumperlocations.Jumperpositions1through3areusedforsetting
the code.
 previous next