Heath Zenith 598-1127-03 Door User Manual


  Open as PDF
of 24
 
A B C 1 2 3
This package includes (Style of push button and chime
may vary from illustration):
• WirelessChristmasbellchime
• Wirelesspushbuttonwithbattery
• Hardwarepack
This chime requires 3 "AA" alkaline batteries (not
included).Intypicaluse,alkalinebatterieswilllastup
to 6 months.
Wireless Christmas
Chime
©2008HeathCoLLC 598-1127-03
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushingintabonbottomwithasmallscrewdriver
(seeFigure1).Seediagraminsidepushbuttonfor
correct battery orientation. Note: If batteries are
preinstalled, remove orange battery tab.
2. Open chime battery compartment. Press in
latch on rear of chime and lift off battery cover
(see Figure 2).
3. Install 3 alkaline "AA" batteries. Make sure
batteries are oriented properly (seeFigure3).
4. Test range. Temporarily position chime and
pushbuttonwhereyouwantthemmounted.
Press push button to verify chime and push but-
tonworkproperly.Ifchimedoesnotsound,see
Troubleshooting.
Figure 2
Figure 1
Keyhole
Jumpers
ABC 1 2 3
Figure 3
WARNING: To prevent possible SERIOUS
INJURY or DEATH:
 
 
doctor.
next