Filter
Top Products
14
Standard or Connections (In.) Approx.
Reverse Flow Dimensions (In.) Coil Shipping
Models H L M W Inlet Suction Drain Wt. (Lbs.)
13 17
3
/
4
16
7
/
8
12
1
/
4
15
5
/
8
3
/
8
OD
3
/
8
OD
5
/
8
OD 19
17 19
3
/
4
16
7
/
8
14
1
/
4
15
5
/
8
3
/
8
OD
3
/
8
OD
5
/
8
OD 20
23 19
3
/
4
23
1
/
4
14
1
/
4
22
3
/
8
OD
1
/
2
OD
5
/
8
OD 28
Mounting
The standard flow mullion unit draws air in at the top and
discharges out the bottom. The reverse flow mullion draws
air in at the bottom and discharges out the top. The unit may
be mounted in a mullion or against a back or side wall.
When mounting to the mullion of under counter refrigerators,
mounting holes are located on both ends of the unit for
attaching to “customer furnished” mounting brackets.
When wall mounted, four “L” type brackets and eight stainless
steel sheet metal screws are provided to attach the brackets
to side panels.
IMPORTANT: A minimum of 2 inches must be provided
between the top of the unit and the top of the cabinet.
Standard & Reverse Air Flow Wall Mullion Unit Cooler
Dimensional Data
25°F Sat. Suction Temp. 20°F Sat. Suction Temp.
Model BTUH @ R-22 BTUH @ R-22
Size 10°F TD Alco Sporlan 15°F TD Alco Sporlan
13 1300 1950
17 1700 HFS-1/4HC EFV-1/5C 2550 HFS-1/4HC
23 2300 3450
Expansion Valve Recommendations
Replacement Parts
Part Standard Reverse
Description Down Flow Up Flow
115V Motor 25300701 25300701
208/230V Motor 25300801 25300801
Fan Blade 5102C 5117C
Fan Guard (13-17) 5076E 5076E
Fan Guard (23) 5077E 5077E
Motor Mount 91179001 91179001
Drain Pan (13-17) 74422002 74422002
Drain Pan (23) 74436002 74436002
FOR FOOD
SERVICE
INSTALLATIONS
. . . seal any joint
between unit cooler
and cooler liner
with a sealant
listed by the
National Sanitation
Foundation,
Standard 51
A top barrier is supplied and must be used if combustible
material is above the unit. On reverse flow models the
barrier may be used to direct the air straight out or up at a
45° angle. Holes and slots are provided to adjust the barrier.
If noncombustible material is used above the unit, the barrier
may be discarded if desired.
Knockouts are provided for bringing the refrigerant piping
through either end of the cabinet. An electrical knockout is
provided into an internal junction box.
Dimensional Diagram
NOMENCLATURE
XXX K 13 A G
KM = Standard Vintage
Air Flow
RAM=
Reverse
Air Flow A = 115-1-60
K =
Coated Coil
B = 208/230-1-60
Size
EFV-1/3C
EFV-1/5C