Filter
Top Products
Figure 14. Placement of the Ember Material
Placing the Ember Material
Ember material is shipped with this gas fireplace. The
bag labeled Golden Ember (GE-93) is flame colorant
material. The bag labeled Glowing Ember (050-721) is
standard glowing ember material. To place the ember
material:
• Remove wing nuts and glass clips or tension springs
around glass door. Remove glass door from unit.
• Place dime size pieces of ember material about 1/2
inch apart near port holes in burner top. Do NOT
press embers into burner ports. Cover the top of
the burner with a single layer of ember material. For
best performance do NOT place embers on the ports
at the rear of the burner.
GLASS SPECIFICATIONS:
LARGE GLASS: TEMPERED
SMALL GLASS: TEMPERED
Heat & Glo fireplaces manufactured with tempered glass
may be installed in hazardous locations such as bath-
tub enclosures as defined by the CPSC. The tempered
glass has been tested and certified to the requirements
of ANSI Z97.1-1984 and CPSC 16 CFR 1202. (Safety
Glazing Certification Council SGCC # 1595 and 1597.
Architectural Testing, Inc. Reports 02-31919.01 and 02-
31917.01.)
This statement is in compliance with CPSC 16 CFR
Section 1201.5 “Certification and labeling requirements”
which refers to 15 USC 2063 stating “…Such certifi-
cate shall accompany the product or shall otherwise be
furnished to any distributor or retailer to whom the prod-
uct is delivered.”
Some local building codes require the use of tempered
glass with permanent marking in such locations. Glass
meeting this requirement is available from the factory.
Please contact your dealer or distributor to order.
• Save the remaining
ember materials for
use during fireplace
servicing. The bag of
embers provided is suf-
ficient for 3 to 5 appli-
cations.
• Replace the wing nut,
glass clips and screws.
• Replace glass door and
a front trim door on unit.
• Hand tighten the wing
nut.
Heat & Glo • ST-42TVFL-IPI • 455-902 Rev. C • 12/07
24