Filter
Top Products
Heat & Glo • SL-350TRS-C, SL-550/750TRS-IPI-D • 2065-985 Rev. J • 5/06
43
Installing the Trim
Combustible materials may be brought up to the specified
clearances on the side and top front edges of the appliance,
but MUST NEVER overlap onto the front face. The joints
between the finished wall and the appliance top and sides
can only be sealed with a 300° F. (149° C) minimum sealant.
WARNING: WHEN FINISHING THE APPLIANCE,
NEVER OBSTRUCT OR MODIFY THE AIR INLET/
OUTLET GRILLES IN ANY MANNER.
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the appliance.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be opened and the trim door removed.
!
Step 10. Installing Trim, Logs and Ember
Material, and Removing Shipping Support
Placing the Ember Material
The bag labeled Mystic Embers is standard glowing ember
material. To place the ember material:
• Unlatch the latches at the top and bottom of the glass door.
• Remove the glass door from the unit (see Figure 40).
Figure 40. Glass Assembly
Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the instructions that accompany the
logs. Save the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
GLASS SPECIFICATIONS:
SL-750TRS-IPI-D .............................................. CERAMIC
SL-550TRS-IPI-D .............................................. CERAMIC
SL-350TRS-C ................................................... CERAMIC
LATCHES
(BOTH TOP
AND BOTTOM)
GLASS
ASSEMBLY
• Place Mystic Embers on base pan on both sides of the
burner. Do NOT place on burner top.
• Glowing embers can only be placed as shown around
the front burner ports. Do NOT cover burner ports (see
Figure 41).
Figure 41
• Reinstall and latch the glass door.
CAUTION: THE GLASS DOOR MUST BE SECURELY
LATCHED BEFORE OPERATING THE UNIT.
EMBERS
MODEL TOP VENTED REAR VENTED
SL-350TRS-C 1/4” open 3/16” open
SL-350TRS-C-LP 1/2” open 3/8” open
SL-550TRS-IPI-D 1/2” open 1/2” open
SL-550TRSLPIPID Full open Full open
SL-750TRS-IPI-D 1/2” open 1/2” open
SL-750TRSLPIPID Full open Full open
Shutter Settings