Filter
Top Products
Heat & Glo LifeStyles Collection • Montana • 4039-150 Rev I • 08/06
11
Note: Fireplace header
cannot be positioned until
the fireplace assembly is
in place.
2 in. minimum air
space clearance
to the enclosure.
42-3/8 in.
A
42-3/8 in. header height.
Use only noncombustible
material below the top of
the top standoffs.
Cat. # A
MONTANA-36 & 36H 43 in.
MONTANA-42 & 42H 49
in.
24-1/8 in.
C. Sidewalls/Surrounds
Adjacent combustible side walls must be located a minimum of 12 in. (305 mm) from the fi replace opening. See Figure 3.4.
If you are using a decorative surround constructed of combustible material, it must be located within the shaded area de-
fi ned in Figure 3.3. Short stub walls are also acceptable if they are contained within the shaded area.
D. Frame the Fireplace
Figure 3.5 shows a typical framing (using 2 x 4 lumber) of the fi replace, assuming combustible materials are used. All re-
quired clearances to combustibles around the fi replace must be adhered to. See Figure 3.2. Any framing across the top of
the fi replace must be above the level of the top standoffs.
14-3/8 in.
12 in.
39
deg.
4 in.
BRICK
FRONT
FLUSH FRONT
12 in.
9-3/4 in.
50
deg.
A
B
Cat # A B
MONTANA-36 & 36H 36 in. 42 in.
MONTANA-42 & 42H 42 in. 48 in.
Figure 3.4 Sidewalls and Surrounds
Figure 3.5 Framing the Fireplace