Filter
Top Products
Heat & Glo • 6000GLX-IPI-S/-R, 6000GLX-IPILP-S/-R • 2101-900 Rev. Q • 11/08 51
C. Doors
Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and fi nishing material is going to be used on the fi replace,
you may use the table below which shows the door mod-
els and the fi nishing material thickness allowed. For an
inside fi t there is an available template to assist with siz-
ing the fi nishing material.
1-2 IN. THICK
FINISHING
MATERIAL
1-2 IN. THICK
FINISHING
MATERIAL
*IF FINISHING MATERIAL IS THICKER THAN
2 IN., DOORS WILL ONLY OPEN
AS FAR AS PICTURED
DOORS
37 1/4 IN.
33 3/4 IN.
34 IN.
Figure 13.6 Inside fi t door
Figure 13.7 Operable hinge door
DOOR
FINISHING
MATERIAL
FINISHING
MATERIAL
(Outside door width)
(Includes 1/8 in. opening each side of door)
37 in.
37-1/4 in.
ELBOW
HEAT
SHIELD
Finishing materials over 1 inch thick.
Finishing material between 1 and 2 inches thick.
37 in.
33-3/4 in.
37-1/4 in.
34 in.
(Outside door width)
(Includes 1/8 in. opening each side of door)
Figure 13.5 Overlap Fit Door
Figure 13.4 Folio Door
DOOR FIT
FINISH
MATERIAL
MAXIMUM
THICKNESS
SEE
FIGURE
Folio Inside Any 13.4
Arcadia
Overlap 1 inch 13.5
Inside Any 13.6
Halston
Overlap 1 inch 13.5
Inside 1 inch - 2 inch 13.7
Chateau
Overlap 1 inch 13.5
Inside Any 13.6
Valencia
Overlap 1 inch 13.5
Inside Any 13.6
Galleria
Overlap 1 inch 13.5
Inside 1 inch - 2 inch 13.7
Stop fi nishing material fl ush with opening.
ELBOW
HEAT
SHIELD
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.