Filter
Top Products
Heat & Glo • 6000GLX-IPI-S/-R, 6000GLX-IPILP-S/-R • 2101-900 Rev. Q • 11/0836
A. Choosing the Top or Rear Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
9
9
Appliance Preparation
Figure 9.2 Cut the seal cap strap across the rectangles
next to the disk.
Figure 9.3 Remove the white gasket material covering
the seal cap.
Figure 9.1 For top vent, remove the two screws holding
the elbow heat shield in place. Use this heat shield over
the fi rst elbow if applicable. For rear vent skip this step.
NOTICE: Once the seal cap has been removed it CANNOT
be reattached.
Figure 9.5 Remove the insulation basket and white insu-
lation from the center vent pipe.
Proceed to Section 7. C.
Figure 9.4 Remove the seal cap.