Filter
Top Products
35
Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. H • 5/12
9
9
Appliance Preparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
A. Top Vent
Figure 9.1 Cut the seal cap strap across the rectangles
next to the disk. For rear vent, skip this step.
Figure 9.2 Remove the white gasket material covering
the seal cap.
Figure 9.4 Remove the insulation basket and white insu-
lation from the center vent pipe.
Figure 9.5 Remove the insulation from the outer vent
pipe. For rear venting there is no insulation in the outer
vent pipe.
Figure 9.3 Remove the seal cap.
Figure 9.6 To attach the fi rst section of vent pipe, make
sure to use the fi berglass gasket in the manual bag to seal
between the fi rst vent component and the outer fi replace
wrap. Use 2 self tapping screws to secure the gasket to
the outer wrap.
Secure the fi rst section of venting to the fi replace by screw-
ing through the two straps left over from cutting the seal
cap strap in step 2.