Heat & Glo LifeStyle 6000C Indoor Fireplace User Manual


  Open as PDF
of 86
 
Heat & Glo • 6000C, 6000C-IPI, 8000C, 8000C-IPI • 2164-900 Rev. T • 9/12
65
Figure7
2
3
1
1
2
3
4
Figure8
Figure9
Figure10
1
1
2
2 3
3
4
5 5
6
4
Log#3(SRV2168-703): Mate the slot located on the bottom of Log #3 with the right log placement tab on top of Log #1.
After slot and tab have been tted together, mate the groove located on the bottom of Log #3 with the horizontal grate bar
and far right grate tine. Log # 3 will sit down on top of both the grate tine and the horizontal grate bar (see Figure 7).
Log#4(SRV2168-704): Place Log #4 in the left log indentation on the burner top (see Figure 2). Slide Log # 4 from right to
left under Log #2 to t completely and securely into the indentation (see Figure 8). The back or Log # 4 should rest against
the far left grate tine as well as contact Log # 2.
Log#5(SRV2168-705): Place Log #5 in the right log indentation on the burner top (see Figure 2). Ensure the log ts
completely and securely in the indentation (see Figure 9). Log #5 should be pulled to the left hand side of log indentation.
Log#6(SRV2168-706): Mate the groove located on the lower end of Log #6 with the fourth tine (from left to right) as
shown in Figure 10. Set the other end of Log #6 on the at area located on top of Log #4 (see Figure 9). Log #6 will
also rest against center grate tine. When properly installed, Log #6 will rest securely on all 3 contact points, not allowing
movement or shifting.
FLATAREA
LOGCONTACTSGRATETINES
LOG#6CONTACTSTOPOFLOG#4
RIGHTGRATETINE
LOG#4CONTACTSLOG#2
HORIZONTALGRATEBAR
2168-935C
 previous next