Heat & Glo LifeStyle 6000C Indoor Fireplace User Manual


  Open as PDF
of 86
 
Heat & Glo • 6000C, 6000C-IPI, 8000C, 8000C-IPI • 2164-900 Rev. T • 9/1264
Models:8000C,8000C-LP,8000C-IPI,
8000C-IPILP,8000CBV-IPI
Figure3
Figure4
GROOVES
SLOTS
Figure5
Figure6
1
2
1
LEFTGRATETINE
CAUTION: Logs are fragile, handle with care. Log#1(SRV2168-701): Locate log placement tabs on the pilot cover. Bend
tabs upward as shown in Figure 2. Locate the log placements slots on the bottom of Log # 1 (see Figure 3). Mate the slots
located on the bottom of Log #1 with the log placement tabs on the pilot cover. Log # 1 is properly installed when it sits
squarely and completely on pilot cover with tabs engaged. See Figure 4.
Figure1
LOGPLACEMENTTABS
LOGPLACEMENTSLOTS
Log#2(SRV2168-702): Mate the slot located on the bottom of Log #2 with the left log placement tab on top of Log #1.
After slot and tab have been tted together, mate the groove located on the bottom of Log #2 with the horizontal grate bar
and slide Log # 2 toward the left until it rests against the far left grate tine.
Figure 4 shows the log placement tabs located on the top of Log # 1. The tabs will be mated with the slots located on the
bottom of Log #2 and Log #3 (see Figure 5). Log #2 and Log #3 also have grooves that allow the logs to be seated properly
on the grate (see Figure 5). Hold Log #1 upright while placing Log #2.
LOGPLACEMENTINDENTATIONS
GRATETINE
LOGPLACEMENTTABS
3
2
Bottomviewof
Logs#2and3
GUIDE SLEEVES
FIBER BURNER TOP
TAB BENT IN = NG
TAB NOT BENT = LP
BURNER ASSEMBLY
PILOT COVER
LOCATING HOLES
BURNER SHIELD
LogAssembly:LOGS-8CG. InstalltheLogAssembly(continued)
Figure2.LogPlacementTabs
 previous next