Heartland 2603 Stove User Manual


 
12
*Note: A chimney approved to ULC standard S629 in Canada or UL 103HT in the U.S. must be used to connect the smokepipe at
the top of the cabinet to maintain the 2” (5.08cm) clearance to combustibles. The approved chimney must extend 1” (2.54cm) below
the heatshield. PLEASE NOTE: That these are factory recommended clearances only, and are subject to local, provincial or state
building and re codes. These clearances may change without notice
Chart of Clearances
When a heat shield is installed dimensions B, D, E and F are taken from
the heat shield.
Dimensions A, C, G, and H remain the same with or with-out a heat
shield.
Dimensions A and C are taken from the reservoir on reservoir models.
When two or more clearances to combustible walls contradict each other,
the clearance with the greater numerical value must be maintained.
Status Model A B C D E F G H J Measure
NO HEAT
SHIELD
SweetHeart
25 69 66 66 50 58 132 61 121 Centimeters
10 27 26 26 20 23 52 24 48 Inches
Oval
25 68 66 91 50 86 132 61 121 Centimeters
10 27 26 36 20 34 52 24 48 Inches
WITH HEAT
SHIELD
SweetHeart
25 8 66 61 5 31 132 61 121 Centimeters
10 3 26 24 2 12½ 52 24 48 Inches
Oval
25 8 66 91 5 44 132 61 121 Centimeters
10 3 26 36 2 17½ 52 24 48 Inches