Filter
Top Products
Heat & Glo • SL-350TRS-CE-D • 2033-900 Rev. N • 10/07
38
Placing the Ember Material
Ember material is shipped with this gas fireplace. The bag
labeled Glowing Ember (050-721) is standard glowing ember
material. To place the ember material:
• Remove latches and tension springs around the glass door.
• Remove the glass door from the unit (Figure 44).
• Place small pieces of ember material on burner top around
burner ports (Figure 33). Do NOT press embers into
burner ports. Cover the top of the burner with a single
layer of ember material. Do NOT place embers behind
the rear port row as noted in Figure 45.
• Save the remaining ember materials for use during fireplace
servicing.
• Replace the glass door and a front trim door on the unit
(see Replacement Parts Section of the manual.)
• Replace the latches and tension springs.
Figure 45. Placement of the Ember Material
Figure 44. Glass Assembly
LATCHES
(BOTH TOP
AND BOTTOM)
GLASS
ASSEMBLY
LOG #6 (SRV540-704): Place log #6 against the second and third grate bars.
If sooting occurs, the logs might need to be repositioned slightly to avoid excessive flame impingement.
6
6
DO NOT PLACE EMBERS BEHIND THE REAR BURNER PORTS.