Filter
Top Products
R
September 1, 2008
7036-135E
Page 37
Mt. Vernon Pellet Insert (AE)
F. Glass Replacement
• Glass is 5mm thick high temperature heat-re-
sistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury
WARNING
Figure 37.1
a. Swing open the face and remove door from the appli-
ance by lifting door off of hinge pins and lay on a flat
surface face down.
b. Using a Phillips head screw driver, remove 4 screws 2
on the top and 2 on the bottom. Remove metal bracket
and then remove the glass. Figure 37.1
c. Replace with new glass with gasket.
d. Re-attached metal bracket with 4 screws.
e. Re-install door over hinge pins and close face.
Remove 4 screws
Glass with Gasket
Metal Bracket