Filter
Top Products
Page 34
7036-135E
September 1, 2008
R
Mt. Vernon Pellet Insert (AE)
acuum out the exhaust area
Loosen all nuts but do NOT Remove
f. Removing the Combustion (Exhaust) Blower
1. The combustion blower is mounted in the bottom
right rear of the appliance. Figure 34.1.
2. Use an 11/32 nut driver to loosen all six nuts, but do
not remove. Rotate the blower and remove from the
housing. Figure 34.2.
3. Set the blower on the floor of the appliance. You do
not need to disconnect the wires.
4. Vacuum out the exhaust area. Figure 34.3.
Figure 34.1
Figure 34.2
Figure 34.3
Combustion Blower