Filter
Top Products
R
September 1, 2008
7036-135E
Page 27
Mt. Vernon Pellet Insert (AE)
H. Quick Start Guide
RA
et at:
: M
MENU
1. At the starting screen, press “MENU”
button once or twice until “MENU”
screen appears.
2. Highlight “FUEL TYPE” using the “UP/
DOWN” buttons to the right side of the
display. Press “SELECT”.
Auto Manual Off
ser ettings
uel T pe
MN
et omfort Level
3. Scroll down and highlight “HARD-
WOOD PELLET” or your fuel type.
unflower eeds
Wheat
L L TION
oftwood ellet
ardwood ellet
5. Press “DONE” to confirm fuel
change.
ON IRM L AN
lease empt hopper
of old fuel t pe and
ensure firebox is clean
lease refer to
section in manual
DONE
2. Highlight “AUTO/MANUAL/OFF”.
Press “SELECT”.
ser ettings
uel T pe
MN
et omfort Level
Auto Manual Off
3. Highlight “MANUAL”. Press “SELECT”.
A TO MAN AL TTIN
Manual
Off
Automatic
Manual
CHOOSING FUEL TYPE
TURNING ON APPLIANCE
7. Fill the hopper with fuel, and if the
hopper was completely empty, or has
run out of fuel, throw approximately
1/2 cup of pellets into the firepot.
8. Be sure the hopper lid and glass
door are both closed.
1. At the starting screen, press “MENU”.
Buttons
U
RA
et at:
: M
EUU
MENU
Wall Control for Reference
6. Press “DONE” twice or wait 15 sec-
onds for starting screen to reap-
pear.
4.
Press “DONE” twice or wait 15 seconds
for starting screen to reappear.
RA
et at:
: M
MENU
4. Now press “SELECT” to choose new
fuel
RA
et at:
: M
MENU
1. At the starting screen, press “MENU”
button once or twice until “MENU”
screen appears.
2. Highlight “TEMP UNITS F/C” using the
“UP/DOWN” buttons to the right side of
the display. Press “SELECT”.
CHOOSING TEMP UNIT:
°F or °C
4. Press “DONE”. Press “DONE” again,
or wait 15 seconds for starting screen
to reappear.
3. Press the “UP” or “DOWN” button
to set desired temperature unit and
press “SELECT”..
R TTIN
lame eight Adjust
Temp ifferential
Temp nits
Auto Manual Off
uel T pe
et omfort Level
ser ettings
MN
2. Highlight “USER SETTINGS” using the
“UP/DOWN” buttons to the right side of
the display. Press “SELECT”.
NOTICE:
Any button pressed will turn on the backlight. Wall control will automati-
cally revert back to the starting screen if there is no activity for 15 seconds; except
for the “CONFIRM FUEL CHANGE” screen.