Hearth and Home Technologies CB1200I-B Stove User Manual


 
Page 36
7014-083E
September 1, 2008
R
CB1200-I Pellet Insert
E. Glass Replacement
Glass is 5mm thick high temperature heat-
resistant ceramic glass.
DO NOT REPLACE with any other material.
Alternate material may shatter and cause
injury
WARNING
o otto ra e
oor Latc
Side
ra
e
Center Posts
lass
Re ove oor Latc irst
and t en Side ra e
oor ra e
s o n it no
lass or lass
ra es
Re ove nuts fro otto ra e
Figure 36.2
Figure 36.1
Remove door from appliance and place face down
on a protected surface to avoid scratching the door.
Remove all door rope.
1. Replacing Center Glass
NOTE: DO NOT LET Air Wash Spacers fall down from
top frame when removing and replacing center
glass.
a. Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off.
b. Using a nut driver remove the (5) bottom nuts and
remove the bottom glass frame. Figure 36.2.
c. Slightly bend up and out of the way the 2 center posts
and slide the glass out the bottom.
d. Slide new glass in, reposition the 2 center posts and
re-install bottom glass frame.
e. Re-rope the door.
2. Replacing Side Glass
NOTE: When removing the side glass with the door
latch, you must remove the door latch first
before removing the side frame. Use a pow-
ered Phillips head screw driver to remove the
4 screws.
a. Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off.
b. Remove side glass frame.
c. Loosen the top and bottom frame and slightly bend
up and out of the way.
d. Slide glass out the side and slide new glass in.
e. Re-install the side glass frame and tighten the top
and bottom frames.
f. Re-install the door latch, if applicable, and re-rope
the door.
o otto ra e
oor Latc
Side
ra
e
Center Posts
lass
Re ove oor Latc irst
and t en Side ra e
oor ra e
s o n it no
lass or lass
ra es
Re ove nuts fro otto ra e
Handle glass with care.
Inspect the gasket to ensure it is
undamaged.
Do NOT strike, slam or scratch glass.
Do NOT operate appliance with glass
assembly removed.
WARNING
Do NOT operate with glass cracked, broken or scratched.