Filter
Top Products
INSTALLING IN A MOBILE HOME
Follow these special requirements for installing your stove
in a mobile home.
• Install the stove in accordance with 24 CFR, Part 3280
(HUD).
• A chimney cap spark arrestor is a requirement in
mobile home installations.
• HearthStone recommends you install at least one
smoke detector.
• Permanently attach the stove to your mobile home’s
floor. Use appropriate bolts through the existing holes
in the legs, or use the clips that secured the Equinox to
the pallet.
• Mobile home installations require the use of an outside
air adaptor kit:
HearthStone Kit # 93-53500 (See page 7)
• Install the following Dura-Vent Mobile Home
Chimney & Connector Kit (or equivalent):
8DP-MH 8” Diameter S/N 9296N
Each kit includes:
Stainless spark arrestor cap, storm collar,
Adjustable vented flashing – 0/12 – 6/12,
Two 24” Dura/Plus* chimney pipes, 24” Support box
with built-in starter section and trim. You must provide
the appropriate connector pipe.
* (UL or ULC approved equipment is acceptable)
• Remove the entire chimney and connector pipe prior to
transporting the mobile home. Flexing of the structure
during movement could damage the chimney
components if not removed.
HearthStone Quality Home Heating Products, Inc ® Equinox Model 8000
15
CAUTION:
MAINTAIN THE STRUCTURAL INTEGRITY
OF THE MOBILE HOME
WALLS, FLOOR,
CEILING, AND ROOF WHEN INSTALLING
AND USING YOUR STOVE
.
WARNING:
DO NOT INSTALL IN A SLEEPING ROOM IN
A MOBILE HOME.