Filter
Top Products
Page 8SKU 92966
For technical questions, please call 1-800-444-3353.
Mounting the Bobbin Winder
Note: Unless indicated otherwise, all parts referred to in this set
of instructions are listed in the Bobbin Winder & Thread
Stand Unit Parts List found on page 23. During assembly,
it will be helpful to refer to that list and the diagram above
it on the same page.
20. Remove the Belt Cover (part 8-27, on page 21). Swing the
sewing machine so the base is in the operating position,
resting on the table. Set the Bobbin Winder to the ‘ON’
Position-see ON Position, below.
21. Make sure the Bobbin Winder is in the ‘ON’ position.
Position the Base (Bobbin Winder Base Assembly) (10-1)
so that the Thread Winder Assembly (10-4) lines up with
and just touches the belt. Mark pilot hole locations on the
table at the far end of each of the two channels in the Base
as indicated in Figure A.
22. Set the Base (10-1) aside and swing the sewing machine
out of the way. Carefully drill straight pilot holes for each of
the two locations marked above. Place the base in location
and secure using two Wood Screws (10-22) and Washers
(10-23). Leave the Screws just loose enough to allow the
Base to slide.
23. Swing the Sewing Machine back into it’s operating position. Put the Bobbin Winder in
the ‘OFF’ position-see OFF Position, below. Slide the Bobbin Winder Assembly close to
the belt until it just barely doesn’t touch it (
1
/
8
” gap or less)-see Figure B, above. Tighten
the Wood Screws (10-22) from step 22, above.
24. Put the Belt Cover back on the Sewing Machine before use.
Figure A
Figure B
Mark
Pilot
Holes
Here.
Figure A
Figure B
Mark
Pilot
Holes
Here.
Setup and Adjustment Section Contents
SECTION PAGE
Bobbin Winder Operation ..................................................................................................9
Setting Bobbin in Case ......................................................................................................9
Needle Attachment ...........................................................................................................10
Threading the Machine .....................................................................................................10
Stitch Length .....................................................................................................................11
Reversing Sewing Direction ..............................................................................................11
Needle Thread Tension .....................................................................................................11
Bobbin Thread Tension .....................................................................................................11
Thread Take-up Spring .....................................................................................................11
Thread Take-up Stroke .....................................................................................................12
Presser Foot Pressure ......................................................................................................12
Presser Bar Height ...........................................................................................................12
Feed Timing ......................................................................................................................12
Feed Dog Height ..............................................................................................................13
Needle-to-hook Timing .....................................................................................................13