Filter
Top Products
Page 6SKU 92966
For technical questions, please call 1-800-444-3353.
7. Tilt the machine back to expose the Oil Pan (D). See figure 5.
8. Fill the Oil Pan with sewing machine lubrication oil (#7 white oil) to the “high” mark “A”.
Add more oil when the level is to the “low” mark “B”. After lubrication, and during opera-
tion, oil splashing can be seen through the Oil Sight Window (H).
9. Lower the machine head to the table top.
10. Mount the Motor to the underside of the table top as shown below. Use the supplied
hardware.
11.
(K)
Note: Top switch
determines rotation.
Switch left for counter-
clockwise; switch right
for clockwise rotation.
Note: Motor is 110/220V
Single Phase. Disconnect
power and flip switch to
desired voltage. Switch left
for 110V, switch right for
220V. For 220 V, the power
plug must be rewired by a
qualified technician.
Note: Receptacle
for 6 volt work light
(not included).
Place the V-belt around the Sewing Machine Pulley, through the slot in the table top, and
around the Motor pulley. Attach the Pulley Safety Cover.
12. Tighten the V-belt tension by adjusting the long bolt and nut at location (K). The proper
tension is reached when the V-belt can only be deflected 1/2 inch.
13. Mount the Power Switch under the table top, on the operator’s side. Use the supplied
hardware.