Filter
Top Products
SKU 47821 For technical questions, please call 1-800-444-3353 Page 17
OPERATING INSTRUCTIONS
Note: During operation, keep all persons and vehicles away from gate wing movement.
“Manual” Mode
1. To open both Gate Wings, press T1 on the Remote Control. The warning light will flash
rapidly and the gates will open.
2. To close the gate wings, press T1 again. The warning light will flash slowly and the gates
will close.
3. To stop the Gate Wings at any time, press T1 once.
“Automatic” Mode
1. To open both Gate Wings, press T1 on the Remote Control. The warning light will flash
rapidly and the gates will open.
2. The gates will automatically close after the time period set by the controls (see Automatic
Gate Wing Closing section for details).
3. To stop the Gate Wings while the gates are closing, press T1 once. The gates will not
stop while opening or opened in this mode.
INSPECTION, MAINTENANCE, AND CLEANING
WARNING! Make sure the Circuit Breaker for the Gate Opener is in its “OFF” position
and that the fuse is pulled from within the Gate Opener Control Box before performing
any inspection, maintenance, or cleaning procedures.
1. Before each use, inspect the general condition of the Gate Opener hardware. Check
for loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, and any other condition that may affect its safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further use. Do
not use damaged equipment.
2. Periodically recheck all nuts, bolts, and screws for tightness.
3. Periodically wash the Actuator Arm (A) stainless steel pistons with mild soap and water.
Do not oil the pistons.
4. Replace the Remote Control Battery every year as follows: Remove the two screws from
the back cover. Carefully open the cover. Remove the current battery. While following the
polarity markings on the plastic housing and the circuit board, install a new battery of the
same kind (“23A”). Carefully close the remote and secure. If the battery replacement is
done in a timely manner, the remote will store its codes in its memory. If not, reprogram
the remote according to the directions earlier in the manual.