Filter
Top Products
Operation instruction
Timer On/Off function
SET
MODE FAN SWING
TEMP
CLOCK
TIMER
SET
SLEEP
FILTER RESET
RESET
ON/OFF
HEAT
11
Before using TIMER function, calibrate the clock first.
2.Set of TIMER mode
Press the TIMER button to change the TIMER mode,
each press the TIMER mode will change as the following
sequence:
1.Turn on the unit
After turning on the unit, set the desired working
mode.
The LCD will show working mode.
The power indicator light on the indoor unit will light up.
Hints:.
After power failure, the clock should be calibrated again.
The remote controller has memory function, when you use this function for the second time,
if the time set is the same as the previous one, you just need to choose the TIMER mode then
press the SET button to confirm.
Each press, the set time increases 10 minutes. If depress the button, the time will
increase rapidly.
Each press, the set time decreases 10 minutes. If depress the button, the time will
decrease rapidly.
3.Set time
Press the time adjusting button
5.Cancel TIMER
Press the TIMER button several times until the TIMER mode display disappears.
4.Confirm the time
After calibration of the clock, press SET button to confirm time.
The time displayed is: at x oíclock x minutes the unit will be turned on
(TIMER ON) or turned off (TIMER OFF).
OFF
ON
Then choose the timer mode as need
(TIMER ON or TIMER OFF.)
At this time the* *or * *will flash.
At this time, the* *or* *will not flash.
OFF
ON
AM
PM
AM
PM
OFF
ON
OFF
TIMER ON TIMER OFF TIMER ON-OFF
Blank
ON
This LCD will show the time set, the time can be adjusted within 24h.
(The minimum interval is 10 minutes).
AM stands for morning, PM stands for afternoon