Filter
Top Products
WaterMax 60 Series Owner’s Manual 11/10/2008 6
Six-Button Controller, Cont.
Controller Part Function
LCD Display Shows the status of the controller
Normal Operating
Mode
Shows
x The amount of soft water remaining until the next automatic regeneration (Each person in
the household uses about 75 gallons per day)
x The number of days until the next regeneration (Mode 1)
x The current day and time and the flow rate in gallons (or liters) per minute
x The time of the next scheduled regeneration (If the Regenerate button has been pressed
and released)
Customer Setting
Mode
Includes setting the time of day, the regeneration time, and the number of people in the household;
depending on the service settings, this option may not be available
Service Settings
Mode
Includes settings such as the language, mode, water hardness, and time of each regeneration
step. Service Settings must be set before Customer Settings. Otherwise, some values may not be
available. Intended for use by qualified service personnel
Water Flowing
Indicator
Indicates that water is flowing through the appliance; useful for checking for proper plumbing and
leaks
Recharge/
Regeneration
Status
Shows regeneration cycle positions during regeneration
Scroll Back Button Steps back to a previous parameter setting without the need to scroll forward through all settings
Change Digit
Button
Used with the Select Digit button to set the value of certain parameters.
Pressing the Change Digit button changes the value under the cursor to the next available value,
typically increasing by one until all values have been displayed and the process begins again
Select Digit Button Moves the cursor when setting parameters
1. Press and release the Select Digit button to move the cursor one digit to the right of the
parameter to be changed
2. When the cursor is at the extreme right position, press the Select Digit button again to
reset the cursor to the extreme left position
Service Settings
Button
Enters the Service Setting programming mode—for use by Hague dealer. See Service Settings
Regenerate Button Used to start an immediate regeneration
Customer
Settings/Next
Button
Enters the Customer Setting programming mode. See Customer Settings