Filter
Top Products
Repair
CleaningCleaning
Cleaning
thethe
the
AutoAuto
Auto
--
-
VentVent
Vent
ValveValve
Valve
After the pop-up has been closed while lling the pot,
the auto-vent valve should release air (you should be
able to hear the air venting).
The pot pressure gauge will not show pressure until
the auto-vent valve has bled all of the air and sealed.
If the auto-vent valve does not release air, or if water
leaks from the stem during the ll process, the stem
valve may be clogged or faulty.
Perform the following procedure to clean a clogged
auto-vent valve.
1. Try to push and quickly release the valve with
your nger. If that does not cause the valve to
seal, open the dump valve to release all of the
pressure in the pot.
2. Turn the selector valve to RINSE.
3. Use the rinse hose to force water backwards into
the valve stem.
NOTE:NOTE:
NOTE:
If the previous steps fail to resolve
the issue, replace the whole valve assembly
(EQ1860).
NOTICENOTICE
NOTICE
The valve stem itself is internally attached to the
oat and it is not eld-serviceable. Do not try to
remove the valve stem. Damage to the equipment
will occur.
334666B31