Filter
Top Products
Operation
ConnectingConnecting
Connecting
thethe
the
BlastBlast
Blast
HoseHose
Hose
andand
and
AirAir
Air
HoseHose
Hose
1. Make sure the inlet hose connections are tight,
and that hose restraints are properly installed
and secure.
2. Open the air supply valve (125 psi, 8.6 Bar, 0.86
MPa maximum). If necessary, use a regulator in
the supply air line to meet these specications.
OFF
START
RUN
NOTE:NOTE:
NOTE:
See air compressor manual for operation
and startup information.
3. Connect the blast hose, hose restraints, control
hoses, and coupler pins.
ti24706a
NOTE:NOTE:
NOTE:
If you are using an electric blast control,
check all of the electrical connections from the
panel to the blast control.
NOTICENOTICE
NOTICE
Make sure no electrical connections will
be exposed to water. Exposure to water
could cause a short circuit and damage the
equipment.
10334666B