Filter
Top Products
Warnings
WarningsWarnings
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specic
risks. When these symbols appear in the body of this manual or on warning labels, refer back to these
Warnings. Product-specic hazard symbols and warnings not covered in this section may appear throughout
the body of this manual where applicable.
WARNINGWARNING
WARNING
DUSTDUST
DUST
ANDAND
AND
DEBRISDEBRIS
DEBRIS
HAZARDHAZARD
HAZARD
Use of this equipment can result in the release of potentially harmful dust or toxic substances
from the abrasive being used, the coatings being removed, and the base object being blasted.
• For use only by sophisticated users familiar with applicable governmental safety and industrial
hygiene regulators.
• Use equipment only in a well-ventilated area.
• Wear a properly t-tested and government approved respirator suitable for the dust conditions.
• Follow local ordinances and/or regulations for disposal of toxic substances and debris.
EQUIPMENTEQUIPMENT
EQUIPMENT
MISUSEMISUSE
MISUSE
HAZARDHAZARD
HAZARD
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the inuence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See TechnicalTechnical
Technical
DataData
Data
in all equipment manuals.
• Do not use this equipment without hose restraints and coupler pins installed on all air and
blast hose couplings.
• Do not blast unstable objects. The high amount of uid ow from the nozzle can potentially
move heavy objects.
• Do not exceed load rating of lift eyes.
• Do not operate equipment on or stand on an unstable support. Keep effective footing and
balance at all times.
• Use uids and solvents that are compatible with equipment wetted parts. See Technical Data
in all equipment manuals. Read uid and solvent manufacturer’s warnings. For complete
information about your material, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the PressurePressure
Pressure
ReliefRelief
Relief
ProcedureProcedure
Procedure
when equipment is not in use.
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer’s replacement parts only.
• Do not alter or modify equipment. Alterations or modications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from trafc areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
334666B3