Filter
Top Products
Setup
16 312747L
5. Install plug (6) in opposite port and torque to 20-30
ft-lbs (27-41 N•m).
NOTE: Occasionally inspect the inside of the hopper
for any leakage of outer cavity heating fluid.
Fill Spray Material
Condition materials prior to adding to hoppers. Ensure
resin materials are thoroughly agitated, homogenous,
and pourable prior to adding to hopper. Stir hardeners
back into suspension prior to adding material to hopper.
1. Disconnect spring strap (7) from front post and
remove lid (1c). Keep connected to lanyard (10).
2. Pour desired amount of spray material through
strainer inside hopper (D). See Table 1: Fluid
Capacities of 20 Gal. Hopper.
3. Tightly secure lid (1c) on hopper (D) and reconnect
spring strap (7).
F
IG. 21: Orientation of Venting Fittings
(45°)
Open Port
Left Side
Shown
F
IG. 22: Remove Lid
F
IG. 23: Fill Spray Material
1c
7
10
D