Filter
Top Products
1. Turn remote control upside down (Fig. 10-1)
2. Battery replacement (your remote control is
battery powered).
• Gently push straight IN on tab as shown
(Fig. 10-1).
– use ball point pen, coin or small screwdriver.
– battery cover snaps open.
• Install new battery in same position.
– use A23, 12 Volt battery.
3. Attach visor clip to remote control (Fig. 10-2)
• Slide visor clip into back of case until it snaps
into place.
4. Remote control operation
• Point remote control at the garage door and
press the button. Door will move.
• Press remote control button again and door
will stop.
• Press remote control button again and the door
will move the other way. The door automatically
stops at the end of the open or close cycle.
Fig. 10-1
Fig. 10-2
Visor clip
Battery
Battery
cover
+
–
Fig. 9-1
Learn
code
button
Radio
signal
indicator
MORE MORE
LIMIT ADJUSTMENT
CLOSE
OPEN
PUSH
LIMITS
TO SET
4
3
2
1
CLASS 2
NEC
NEC
CLASS 2
1
2
3
4
5
6
MORE
FORCE
PUSH
BUTTON
SAFETY
BEAM
LIMIT
SET
OPEN
FORCE
CLOSE
FORCE
RADIO
SIGNAL
LEARN
CODE
COM
DO NOT
PUSH
LIMIT SET
UNLESS
DOOR IS
ATTACHED
NOTE:
USE ONLY WITH
SERIES II CONTROLS
CLOSE
MORE
OPEN
MORE
CLOSE OPEN
LIMIT ADJUSTMENT
U.S. Patent No. 5,243,784
5,221,869
STEALTH
PRO-MAX
• Press and release a remote control button.
– LED on power head stops blinking.
• Press and release same remote button again.
– LED goes out. Remote is now programmed.
2. Program multi-button remote control
• Repeat step 1 (“program one-button remote” for
each button).
NOTE: Each button on a multi-button remote control
is for a different operator.
3. Operate remote control
• Point remote control at door
– Door moves
• Press button again
– Door stops
• Press button again
– Door reverses
NOTE: Door automatically stops at end of open or
close cycle.
4. Erasing all receiver memory
• Press and hold learn code button on
power head
– 10 seconds or until light goes out
– Memory is erased
• Program door operator again
• Press remote control button once within
30 seconds
– LED on power head stays lit
• Press remote control button again
– LED on power head goes out and remote
control is programmed
NOTE: If LED blinks approximately 4 times per
second, programming has stopped. If programming
stops, repeat above steps.
Radio
signal
indicator
Learn
code
button
25
10
...
BATTERY / VISOR CLIP INSTALLATION