Filter
Top Products
Fig. 1-4
Adjusting
Bolt
WHAT TYPE OF DOOR DO YOU HAVE?
Look at the drawings below. They tell you where
to find the installation instructions you need
Track Guided Doors
SEE SECTION 2A
Trackless Doors
SEE SECTION 2B.
Section Door With
Curved Track Hardware
1-Piece Door With
Horizontal Track Hardware
Curved
Track
with
Vertical
Section
Straight Track
(Horizontal Only)
1-Piece Door
Jamb Type Hardware
(No Track)
1-Piece Door
Pivot Type Hardware
(No Track)
5. Fasten rail to power head.
• Align mounting holes of sprocket saddle, rail
and power head frame.
• Insert the two (2) 5/16” x 1/2” hex head
screws[112], then two (2) No. 10-24 x 1/2” hex
head screws [69].
• Tighten screws.
NOTE: Inner-slide/bullet should remain at mid-travel
when assembling to power head to provide proper
travel when setting limits.
6. Use adjusting bolt to set chain tension (Fig. 1-4)
• Chain should sag slightly but not so much that it
drags on the rail.
“H”
“H”
“H”
DOTTED LINE AT “H”
INDICATES HIGHEST
POINT OF TRAVEL
“H”
2
...
INSTALLATION
FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM
11
WARNING:
IMPORTANT
INSTALLATION
INSTRUCTIONS
1. READ AND FOLLOW ALL SAFETY, INSTALLATION AND
OPERATION INSTRUCTIONS. If you have any questions or
do not understand an instruction, call your service
representative.
2. Do Not install operator on an improperly balanced door. An
improperly balanced door could cause severe injury. Repairs
and adjustments to cables, spring assembly, and other
hardware must be made by a trained service person using
proper tools and instructions.
3. Remove all ropes and disable all locks connected to the door
before installing operator.
4. Install door operator 7 feet or more above the floor. Mount the
emergency release knob 6 feet above the floor.
5. Do Not connect the operator to the source of power until
instructed to do so.
6. Locate the control button:
• Within sight of door.
• At a minimum height of 5 feet, so small children cannot
reach it.
• Away from all moving parts of the door.
7. Install the entrapment WARNING label next to the wall button or
console. Install the emergency release tag on, or next to, the
emergency release.
8. The operator must reverse when the door contacts a 1-1/2 inch
high object on the floor at the center of the doorway. This is about
the size of a 2” x 4” board laid flat.
To reduce the risk of
severe injury or death:
WARNING:
OPEN ORANGE PARTS BAG