Filter
Top Products
35
ge.com
WALL CASE WITH RAD10 DRAIN KIT
External Drain. See page 36 for internal drain.
SEE PAGE 36 NOTE #6
SCREWS
REAR
GRILLE
“A”
METAL
“B”
PLASTIC
SQUARE DRAIN HOLES
NEOPRENE SPONGE GASKET
1/2" O.D. 90° ELBOW DRAIN TUBE
STEEL MOUNTING PLATE
USE TYPE “A” SCREW FOR METAL CASE (RAB71)
AND TYPE “B” SCREW FOR MOLDED CASE (RAB77)
Alternate
6" long, 1/2"
O.D. straight
copper tube.
NOTE: SHADED PARTS AND
SCREWS ARE INCLUDED
WITH RAD10 DRAIN
KIT. USE EITHER THE
90° ELBOW TUBE OR
THE STRAIGHT TUBE
DEPENDING UPON
THE REQUIREMENTS
OF THE PARTICULAR
INSTALLATION.
WALL CASE
ROOM
CABINET
PROJECTION
BEYOND WALL
CASE
90° ELBOW
DRAIN TUBE
MIN. 2 SUPPORTS
FIELD SUPPLIED
FLOOR
CASE ANGLES (FIELD SUPPLIED)
TYPICAL INSTALLATION
Caulk around
perimeter of
wall case all
four sides
where it joins
the building.
3"
4"
WATER DRAINAGE - Precipitation entering the unit through the outdoor louver may not be removed entirely by the
condensate removal system. The base pan flange is designed to allow excess water, either condensate water or
precipitation, to flow into the wall case and drain through two drain holes in the rear of the wall case. If there is more
water in the wall case than can be drained through these holes it will drain through the three overflow drain holes.
These drain holes must not be blocked when mounting or caulking the wall case.
For those installations where water draining from the drain holes is objectionable or where positive drainage is desired,
the RAD10 drain kit is available with either a 90° elbow or a 6" straight tube to be used either to connect to a field sup-
plied drain line or to allow the water to drip free rather than drain down the surface of the building.
NOTE: Drain kit using either the 90° elbow tube or the straight tube may be installed without modification when using
RAG60 exterior grille. Drain kit using the 90° elbow tube may be installed without modification when using RAG61
through RAG63 exterior grilles. Modification must be made to the RAG61 through RAG63 exterior grilles when using the
straight tube. Modification must be made to the RAG67 grille if using either the 90° elbow tube or the straight tube (see
installation instructions with the RAG67 grille).