Stovax P8700CFCHEC Stove User Manual


 
13
IMPORTANT: 





SERVICING
1. SAFETY PRECAUTIONS
1.1 For your own and other’s safety, you must install this
appliance according to local and national codes of practice.
Failure to install the stove correctly could lead to
prosecution:
 
stove.
1.2 These instructions must be left intact with the user.
1.3 Do not attempt to burn rubbish on this appliance.
 
 
allow adequate clearance above the appliance.
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN
USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO
RELIGHT THE APPLIANCE.
2. INSTALLATION OF THE APPLIANCE
1.1 This appliance can be installed in four different ways:
1) Builder’s opening with a frame
2) Builder’s opening without a frame
3) Stud work with a frame
4) Stud work without a frame




 
 
1.2 The Studio is supplied with a flue fixing plate to attach the
flue to the appliance within the aperture, Diagram 1.
AR1010
1

without a liner, it must be converted to a rear exit:
 
assembly
 
 
AR2007
2
The flue must be in good condition and clear products of
combustion, see Commissioning)

rigid twin wall flue pipe.
THE APPLIANCE IS SUPPLIED WITH A WALL BOX
CONTAINING THE BATTERIES AND TOUCH PAD. THIS
MUST BE RECESSED INTO THE WALL WITH ACCESS
FOR THE CABLES PRIOR TO FITTING THE APPLIANCE.
2.1 Remove the appliance from the carton and discard all

away when unpacking.
2.2 To access the controls and gas inlet:
 
splitter plate. See Section 4
2.3 The gas supply enters the fire through a silicon panel on the
floor under the access panel, Diagram 3:
 
pipe, Diagram 1
INSTALLATION INSTRUCTIONS
INSTALLATION