Stovax Huntingdon 30 Stove User Manual


 
11
INSTALLATION INSTRUCTIONS
INSTALLATION
3.5 The flue system can now be connected to the stove:
Ensure all joints are sealed with a suitable fire resident
sealant.
We recommend you use self-tapping screws at the flue
spigot joint.
3.6 Connect a suitable pressure gauge to the test point
located on the inlet fitting,
Turn the gas supply on
Light the appliance and check all gas joints for gas
soundness
Turn the appliance to a maximum and check that the
supply pressure is as stated on the databadge.
Turn the gas off and replace the test point screw
Turn the gas on and check the test point for gas
soundness.
3.7 REMOVING THE DOOR
For rear flue exit:
Lift the top of the appliance off and put to one side.
For top flue exit:
Lift and support the top to give clearance, Diagram 4
Lift the front upwards until it is clear of the slots
Pull towards you away from the stove, Diagram 5
Remove the glass frame by undoing the frame fixing
screws and lifting clear, Diagram 6
5
AR1908
4
AR1908
ADVICE ON HANDLING AND DISPOSAL OF FIRE CERAMICS
The fuel effect and side panels in this appliance are made
from Refractory Ceramic Fibre (RCF), a material which is
commonly used for this application.
Protective clothing is not required when handling these
articles, but we recommend you follow normal hygiene
rules of not smoking, eating or drinking in the work area
and always wash your hands before eating or drinking.
To ensure that the release of RCF fibres are kept to a
minimum, during installation and servicing a HEPA filtered
vacuum is recommended to remove any dust accumulated
in and around the appliance before and after working on it.
When servicing the appliance it is recommended that the
replaced items are not broken up, but are sealed within
heavy duty polythene bags and labelled as RCF waste.
RCF waste is classed as stable, non-reactive hazardous
waste and may be disposed of at a licensed landfill site.
Excessive exposure to these materials may cause temporary
irritation to eyes, skin and respiratory tract; wash hands
thoroughly after handling the material.
Put the flame baffle onto the burner and push against the
rear tray lip, Diagram 7
Place the rear panel against the spacer brackets and slide
it down to sit on the ledge of the flame baffle, Diagram 8
AR0359
7
spacer bracket
flame baffle
burner
flame baffle
4. FUELBED ARRANGEMENT
6
AR1909