Filter
Top Products
23
Standard Window Installation
STEP 1. After removing the unit from shipping carton, (See Figure 14).
STEP 2. Attach curtain assemblies to cabinet as shown in Figure 13.
Use eight (8) No. 8 x 3/8" slotted hex head screws (item #1,
page 22).
WARNING
Falling Object Hazard
Not following Installation Instructions
for mounting your air conditioner can
result in property damage, injury, or
death.
CAUTION
Cut/Sever
Although great care has been
taken to minimize sharp edges
in the construction of your unit,
use gloves or other hand
protection when handling unit
Failure to do so can result in minor
to moderate personal injury.
CAUTION
Excessive Weight Hazard
Use two or more people when
installing your air conditioner.
Failure to do so can result in
back or other injury.
FRR085
SHELL SUPPORT
CHANNEL
CURTAIN
ASSEMBLY
(LEFT)
CURTAIN
A
SSEMBLY
RETAINING
BRACKET
CURTAIN
ASSEMBLY
(RIGHT)
SCREW #8 x 3/8” SLOTTED HEX HEAD
(ILLUSTRATION ON PAGE 22, ITEM #1)
8 REQUIRED (4 EACH SIDE). INSTALL
FROM INSIDE SLEEVE TO CURTAIN
ASSEMBLY RETAINING BRACKET.
STEP 3. Center cabinet in window with sill channel positioned against
window stool as shown in Figure 15, Section A-A.
STEP 4. Pull window sash down behind Shell Support Channel on top
of cabinet; this helps hold cabinet in place. Install No. 8 x "
hex head screw (item #3, page 22) in sill channel at bottom of
window opening as shown in Figure 15.
STEP 5. Extend the sliding curtains on each side so the frames fi t into
the window channels. While holding the curtain frames in
place, mark four (4) hole locations (hole locations are in the
upper corners on left and right curtain assembly), two (2) in the
window jamb and two (2) in the window sash. Slip the curtains
back from marked locations and drill four (4) 7/64" diameter
pilot holes. Again, extend the sliding curtains on each side
and then install two (2) No. 8 x ½" Phillips head screws (item
#2, page 22) and two (2) No. 8 x 1 ¼" Phillips head screws
(item #4) through the curtain frames as shown in Figure 15.
FRR086
WHEN CARRYING OR HANDLING UNIT, OBTAIN ASSISTANCE
OR HELP AS NECESSARY TO SUPPORT UNIT FROM BOTTOM
(BASEPAN), MAINTAINING CLEARANCE FROM ALL OBSTACLES.
TO PULL UNIT FROM SLEEVE, USE THE SIDE HANDLES
LOCATED ON EITHER SIDE OF THE UNIT DECORATIVE
FRONT. OBTAIN ASSISTANCE OR HELP AS NECESSARY
TO HOLD SLEEVE WHILE PULLING UNIT FROM SLEEVE.
MAKE SURE AIR CONDITIONER IS ON FIRM SUPPORT
BEFORE REMOVING UNIT FROM SLEEVE.
SIDE HANDLE
Figure 14
Figure 13