FMI P325E(B) Indoor Fireplace User Manual


  Open as PDF
of 32
 
www.fmiproducts.com
108794-01G14
0.5"
0.5"
Figure 22 - Pan and Ember Material
Clearances
Grate
Burner Pan
Pan and Ember
Material
EMBER AND PAN MATERIAL
PLACEMENT
1. Open bag(s) of vermiculite and ll entire
burner pan until burner tube is completely
covered (see Figure 20).
2. Smooth pan material just even with edges
of burner pan.
3. Remove ember material from bag and
atten small amounts into quarter size
pieces and lay on top of surface of pan
material (see Figure 21).
4. Place just enough to cover entire surface
and leave about a 1/2" gap under lower
grate members to allow air to ow (see
Figure 22).
Figure 20 - Fill Entire Burner Pan with
Vermiculite (P324E, VP325E Shown)
Figure 21 - Ember Material on Surface of
Pan Material (Vermiculite)
(P324E, VP325E Shown)
Vermiculite
(Pan Material)
Burner Pan
Grate
Ember Material
Burner
Pan
Vermiculite (Pan Material)
Grate
FIREPLACE INSTALLATION
Continued
LOG PLACEMENT FOR P324E/
VP324E MODELS
1. Place front log (log 1) onto front of grate
sliding log all the way forward against
grate ngers (see Figure 23).
2. Insert pegs on bottom of rear log (log 2) into
holes in rear of grate (see Figure 23).
3. Place log 3 into notches on left side of
logs 1 and 2 (see Figure 24, page 15).
4. Place log 4 into notches on right side of
logs 1 and 2 (see Figure 24, page 15).
To enhance the look of the hearth you may
optionally place provided lava rock around
front and sides of burner.
NOTICE: Do not put lava rock
insidetheburnerpanoraround
theairmixertting.Placinglava
rock inside the burner pan or
blockingtheopeningsofthepro-
pane/LPair-mixer couldcause
performanceproblems.
Figure 23 - Installing Logs 1 and 2
Log 1
Log 2
 previous next