www.fmiproducts.com
108794-01G16
FIREPLACE INSTALLATION
Continued
COMBUSTION AIR KIT MODEL AK4
(OPTIONAL)
The outside air kit may be installed on the left
side of replace only. The vent can be installed
through any outside wall a minimum of 3 feet
below replace termination cap. The handle to
operate damper door for the outside air inlet
will be located inside the left “screen pocket”
of rebox (see Figure 29). Pull handle to open
or push to close.
CAUTION: Air inlet ducts are
nottoterminateinatticspace.
Figure 29 - Air Kit Handle Location
Air Kit
Handle
Screen
Pocket
APPLIANCE ENCLOSURE
Before nishing enclosure around appliance,
inspect all joints around outer surround. Any
gaps between nailing anges and framing
should be sealed with noncombustible insula-
tion or caulking.
If mounted on a raised platform, it must be a
continuous surface and not on blocks without
a solid surface. This will prevent entry of cold
air by means of conduction through total bot-
tom of appliance (see Figure 30).
Side
Framing
Side
Framing
Caulk Here
Pack Insulation
Figure 30 - Sealing Between Appliance
and Framing
INSTALLING OPTIONAL GLASS
DOOR ACCESSORY
CAUTION: Use only glass
doorscertiedforusewiththis
appliance.
Note: Glass door may be heavy for some
individuals. If this is the case, please request
help.
These B-vent replaces are approved for
use with optional bi-fold glass doors (see Ac-
cessories, page 25). The glass panels may
be ordered and installed anytime after the
replace installation is complete.
Follow these steps to install left and right
panels:
1. With handle at the bottom, completely fold
panel on its hinges.
2. With handle facing center of rebox open-
ing, insert lower pivot pin on glass door
panel into hole in pivot plate on bottom
edge of replace opening (see Figure 31,
page 17).
3. Keeping folded door tilted, slide upper two
pins into guide track found under upper
facial edge of rebox opening.
Figure 28 - Logs Installed
NOTICE: Do not put lava rock
insidetheburnerpanoraround
theairmixertting.Placinglava
rock inside the burner pan or
blockingtheopeningsofthepro-
pane/LPair-mixer couldcause
performanceproblems.