Filter
Top Products
33
Problem Solution
No image on parent unit screen Press the display button. You can also change the voice acti-
vated setting to
. The video screen automatically turns on
when baby makes noise.
Batteries in parent unit are weak or dead. Use AC adaptor/
charger and to charge the battery and as a power source.
Camera lens is obstructed.
Adjust the camera angle.
Parent unit beeps and out of
range screen displays
.
Parent unit is out of range of camera. Move parent unit closer
to camera.
Note: Range varies depending on surrounding conditions such
as noise levels, physical obstructions and signal interference.
Under optimal conditions, the range is up to 450 feet.
Turn the parent unit to change the orientation.
Camera power is off. Turn camera power on.
Do not block the internal antenna on parent unit.
Loose power cord connection and camera power is off. Check
camera docking station power cord plug-to-outlet connection.
No power to wall outlet and camera power is off. Make sure
light switch that controls power flow to wall outlet is on.
Power is off because circuit breaker for room is off. Make sure
house fuses and circuit breakers are on.
Parent unit power button
does not light
Parent unit power is off. Turn parent unit power on.
Battery pack in parent unit is weak or dead. Use AC adaptor/
charger to charge the battery and as a power source.
Power is off because circuit breaker for room is off. Make sure
house fuses and circuit breakers are on.
No power to wall outlet and power is off. Make sure light switch
that controls power flow to wall outlet is on.
Problems & Solutions