Filter
Top Products
– 31 –
86(5)81&7,216
Remote Phone Control Feature
Enter:
(within eight seconds)
Your user code
The system status will be announced.
Remote Phone Control Commands
To remotely disarm system:
+
[1]
Your user code
To remotely arm in AWAY mode:
+ [2]
Your user code
To remotely arm in STAY mode:
+ [3]
Your user code
To remotely arm in AWAY or STAY mode with no delay:
+
[2] or [3] + [0]
Your user code
To remotely activate X-10 devices 1-6: [#] + [4] + device no.
To remotely activate X-10 devices 7 & 8:
+ [#] + [4] + device no.
Your user code
To remotely deactivate X-10 devices 1-6: [#] + [7] + device no.
To remotely deactivate X-10 devices 7 & 8:
+ [#] + [7] + device no.
Your user code
To remotely Bypass zones:
+ [6] + zone no.
Your user code
To remotely activate Forced Bypass:
+ [6] + [#]
Your user code
To remotely check system status: [*]
To end remote phone session: Hang Up or
+ [9]
Your user code
NOTES
: (1) Check with your installer to see if the Forced Bypass mode has been enabled.
(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been bypassed.