Filter
Top Products
– 24 –
86(5)81&7,216
Clock/Calendar
Your system can display the current time (see your installer). The date is not displayed, but has an internal
function.
The system must be disarmed with no faults present.
To set the time and date:
+
FUNCTION
+
[63]
Master user code or
Installer Code
NOTES:
1. The keypad beeps twice for invalid data entries (e.g., an hour greater than 12), and the entry will not be
accepted. The keypad beeps once for valid entries.
2. Clock-Setting mode automatically ends if no keys are pressed for one minute.
3. Daylight savings time may have been programmed to automatically begin and end.
4. It is not possible to enter the real time clock programming mode from a wireless keypad (i.e. Ademco 5827)
5. It is not possible to enter the real time clock programming mode when either FC or CA is displayed on the
display.
Hour
(The current hour will be displayed with the AM/PM indication.)
Enter the 2-digit hour (i.e., 01-12).
Press [*] to accept the entry and continue to the AM/PM selection.
Press [#] to exit Clock-Setting mode (keypad beeps 4 times).
AM/PM
(The current AM/PM setting will display A or P.)
Enter 1 for PM or 0 for AM.
Press [*] to accept the entry and continue to the minute selection.
Press [#] to return to hour-setting prompt.
Minute
(The current minute will display.)
Enter the 2-digit minute (i.e., 00-59).
Press [*] to accept the entry and continue to the month selection.
Press [#] to return to AM/PM setting.
Month
(The current month will display.)
Enter the 2-digit month designation (i.e., 01-12).
Press [*] to accept the entry and continue to the day selection.
Press [#] to return to the minute setting.
Day
(The current day of the month will display.)
Enter the 2-digit day of the month (i.e., 01-31).
Press [*] to accept the entry and continue to the year setting.
Press [#] to return to the month setting.
Year
(The current year will display.)
Enter the last two digits of the year (i.e., 00-99).
Press [*] to accept the entry and exit Clock-Setting mode (keypad beeps 4 times).
Press [#] to return to the day setting.