Filter
Top Products
– 28 –
86(5)81&7,216
Scheduling User Interface
Event Identifier Entries
Entry Event Comment
0 Empty No event scheduled (or schedule is temporarily disabled)
1 X-10 Device Turn an X-10 device, either on or off at begin/end times. (will
have a start and end time to program)
(time driven)
NOTE:
SH10A siren cannot be used.
2 Latch Key Report Send a special pager report (7110000) indicating system not
yet disarmed. (will have a start/end time to send the report)
(window driven), (reports only to pager)
NOTE:
Option *49 must be programmed to be 6 or higher.
Make sure unit is armed prior to start of window time.
In addition a secondary phone number must be
programmed in Option *42.
3 Automatic Stay Arming Will arm the system automatically, and bypass any open
zones, at a given time. It will send a report to the pager and
central station, indicating system has been auto armed stay,
plus all bypass reports. (will have only a start time to send the
report)
(time driven)
NOTES:
(1)
Prior executing auto stay arming, force bypass
will be executed - if option *23 was enabled.
(2) If pager report is required, Option *49 must be
programmed to be 6 or higher.
4 Reminder Announcements Will beep three times and then announce custom words 72,
73 and 74. This will be repeated every minute until a key is
depressed, or a button type zone does an arm or disarm.
†
NOTE:
Make sure installer programmed custom words 72-74
at the time of installation.
5 Alarm Clock Will start a trouble tone (beep) on the speaker, which will
continue until a key is depressed.
†
†
The beeping sounds will be terminated when any key is pressed during a remote phone control session.
Figure 1.