Filter
Top Products
Testing the System
(cont'd)
- 33 -
Walk in front of any interior motion
detectors (if used) and listen for three
beeps. The keypad should display the
identification of the detector when the
detector is activated. The display will clear
when no motion is detected. Note that if
you are using wireless motion detectors,
there is a 3-minute delay between
activations. This is to conserve battery life.
To test all smoke detectors, follow the
manufacturer's instructions. The keypad
should display the identification of each
detector when each is activated.
If you experience a problem with any
protection point (no confirming sounds, no
display),
CALL FOR SERVICE
IMMEDIATELY.
When you have checked (and closed, where
necessary) all protection points, no zone
identification numbers should be displayed
on the keypad.
When you complete testing, exit the TEST
mode by continuing with step 5.
5.
+
1
(Security Code)
OFF
Exit TEST mode.
Enter your security code and press the
OFF key.
If you inadvertently leave the test mode
active, it automatically turns off after
approximately 4 hours.