Filter
Top Products
- 28 -
Paging Feature
General Information
If the Paging feature has been programmed for your system, your
pager will respond to certain conditions as they occur in your system.
This message appears in a 7-digit format explained below. You can
also send up to 16 additional digits that may consist of PIN numbers,
messages, reminders, etc. These 16 digits are programmed by your
installer and will appear before the standard 7-digit message.
The [D] button, when pressed (if available), sends a special message
to a pager and displays
Pager Msg sent
on the keypad for 30 seconds
(on an alpha keypad). The message it sends is coded as 999-9999 and
signifies ANY message the user and recipient have decided is
appropriate.
Code Format
The 7-digit condition code that follows takes the following form:
SSS-
00EE
SSS = 3-digit event code: 911 = Alarm
811 = Trouble
101 = Opening (disarm)
102 = Closing (arm AWAY)
00EE = The first 2 digits will always be 00. They are followed by the
2-digit user number or zone number, depending on the event
code.
Examples
Pager displays: 911–0004 . This indicates that your system is
reporting an alarm (911) due to a fault in zone 4 (04).
Alarm
and
trouble
codes are always followed by the zone numbers in which they
occur.
Pager displays: 101–0011
. This indicates that your system is
reporting an open (101) by user 11 (0011).
Opening
and
closing
codes are always followed by the code number of the person who
caused it to happen. User codes are individually assigned and
programmed into the system by your installer.