Filter
Top Products
14 Installation (for qualified installers only)
Travis Industries 4081229 100-01207_000
Light Bulb Installation
Carefully remove the 11 light bulbs from the packaging and install into the sockets following the directions below.
.WARNING: Do not over-tighten the bulbs when screwing them in. The base of the bulb is fragile
and may break if over-tightened. Do not grasp the bulb by the tip. THE BULBS ARE
NOT COVERED BY THE WARRANTY.
1 Carefully remove the bulb from the packaging. Do not hold the bulb by the tip. Grasp it by the center
cylinder.
2 Carefully screw the bulb into the socket until it bottoms out – it does not need to be tight.
3 Repeat this process for the remaining bulbs.
.HINT: The light bulbs have an electric “flame” that tilts from side to side
when in operation, creating a flicker. To maximize the bulb’s
visual effect, we recommend that you install the bulb with the
“flame” tilting side to side, not front to back. To properly align the
bulbs, we recommend the following steps:
1. Gently tilt the bulb side to side to identify how the flame is
positioned.
2. Carefully screw the bulb into the socket following the directions
above.
3. Loosen the base of the socket holder and swivel it until the bulb is
properly aligned. Re-tighten the base to secure.
Cylinder Installation
The cylinders (stone, frosted, or wax) include instructions for installation. Follow these instructions, taking
care to not damage the bulbs during installation.
Crushed Glass Installation
After the candles are properly aligned, pour the crushed glass onto the firebox floor. Use glove to
carefully even out the glass on the firebox floor, making sure it is evenly distributed.
Do NOT grasp the
bulb by the tip.
NOTE: the insulating
cardboard sleeve is not
shown in these pictures.
Make sure it is in place
to protect the wiring and
connections.