Filter
Top Products
Installation (for qualified installers only) 13
© Travis Industries 4081229 100-01207_000
Steps for Finalizing the Installation
Listed below are the steps needed to finalize the installation of the fireplace. Take care when finalizing the fireplace
to not allow dust or other debris to enter the firebox. We recommend finalizing the installation after all construction
work has been completed.
Mirror Preparation
.WARNING: Clean the mirror only with soap and water. Windex® or other glass cleaners will
damage or cloud the acrylic surface of the mirror.
This fireplace is shipped with two side mirrors and an optional back mirror. Before removing the protective coating
from the mirrors, make sure the back mirror is in place or removed (see the two options below). Take care when
working inside the fireplace to not scratch the mirror surface. The mirrors are acrylic and will scratch easily.
NOTE: Two-sided installations do not use a back plate or mirror.
BLACK PANEL BEHIND CANDLES
If you desire a black pane behind the candles, follow the steps below:
1 Remove the front panel and candle tray.
2 The rear mirror is held in place with Velcro along the top of the mirror. Gently pull the mirror off the Velcro
and remove it from the firebox.
3 Cut the tape holding the back panel in place. Lift the back panel up and away from the fireplace.
4 Place the front panel on the back of the fireplace. You may wish to tape the panel in place to insure it does
not become dislodged.
MIRRORED PANEL BEHIND CANDLES
The back mirror is shipped in place behind the candle tray.
ADDITIONAL INSTALLATION OPTIONS
In some cases the fireplace may be installed with the back panel facing the room. In these cases the mirror and/or
front and back panels may be reversed to achieve the correct configuration.