Filter
Top Products
Assembly
Motor
Assembly
Ceiling Bracket
Assembly
Housing
Ceiling Bracket
Figure 1
Figure 2
How to Assemble Your Ceiling Fan
9
1. Assemble the motor assembly to ceiling bracket
assembly using the previously removed hex nuts and
securely tighten all hex nuts. (Figure 1)
2. Assemble the housing to ceiling bracket assembly
using the previously removed screws and securely tighten
all screws. (Figure 2)
How to Assemble the Ceiling Fan Blades
x 9
x 9
FLAT WASHER
WASHER HEAD
SCREWS
HARDWARE USED:
1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a phillips screwdriver, tighten 3/16Ý-24 x 15 mm
washer head screws and flat washers to secure the
blade to the blade holder. (Figure 1)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
3/16Ý-24 x 15 mm
3/16Ŋ-24 x 15 mm
Washer Head Screws
and Flat Washer (3 each per blade)
BLADE
Blade Holder
Figure 1