Filter
Top Products
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
32
ArtNo.320-0002a Proplus oven door side screws
ArtNo.320-0006 Oven door hinge adjustment 1
ArtNo.320-0007 Oven door hinge adjustment 2
6 Doors
6.1 To Remove the Grill Door
Remove the left-hand side panel (see 1.2). Remove
the plinth (4 screws) and the central vertical cover
(5screws). Remove the 2 countersunk screws (1 each
side) securing the grill hinge arms to the front of the
grill chamber.
Note: The arms are spring tensioned. Carefully remove
the grill door. Retain the gaskets.
Reassemble in reverse order, making sure that the
gasket is tted between the hinge arm and the front of
the grill chamber.
6.2 To Replace the Main Oven Door
Open the oven door. Support the door and loosen the
2 screws securing the upper hinge and gasket to the
cooker front (Fig.9-6).
The door is heavy, so take care.
Support the door and remove the screw nearest the
hinge pin (Fig.9-7). Swing the hinge up and away from
the door hinge pin. Lift the door away from the lower
hinge and remove.
Reassemble in reverse order.
6.3 To Adjust the Main Oven Door Angle
The bottom hinge of the main oven door can be
adjusted to alter the angle of the door (Fig.9-8). Loosen
the bottom hinge xing screws and use the notch and
a at bladed screwdriver to move the position of the
hinge to set the hinge position (Fig.9-9).
Retighten the hinge screws.
6.4 To Replace the Main Oven Door Outer Panel
Move the cooker forwards to gain access to the sides.
Open the main oven door slightly and remove the
4front panel xing screws from the door sides (2 each
side), (Fig.9-10). Carefully lift o the outer door panel.
Remove the door handle from the panel by unscrewing
the 2 retaining nuts.
Fit the door handle to the new panel.
Fit the panel to the door. Reassemble in the reverse
order.
6.5 To Change the MainOven Door Latch
Remove the main outer door panel (see 6.4). Remove
screws ‘B’, which hold the latch assembly to the inner
door panel (Fig.9-11). Fit the new catch and reassemble
in reverse order. Check the door operation.
6.6 To Adjust the Main Oven Door Catch Keep
Open the main oven door, slacken o the locknut at the
base of the keep, and screw in or out as required until
the required t is obtained. Retighten the locking nut
(Fig.9-12).
Fig.9-9
Fig.9-10
Fig.9-8
ArtNo.320-0001 Door hinges
1
ArtNo.320-0001 Door hinges
2
Fig.9-6
Eect of hinge adjustment – exagerrated for clarity
Centreline of hinge pin
Oven door omitted for clarity
Fig.9-7
ArtNo.320-0003 Oven door latch
B
Fig.9-11
ArtNo.320-0004 Oven door keep
Fig.9-12