Filter
Top Products
1
2
3
4
THREADING THE BOBBIN CASE
Hold the bobbin between the thumb and forefinger of your right
hand and pull off about 15cm (6 inches) of thread.
2. Pull the thread into the slot in the edge of the bobbin case.
1. Hold the bobbin case in your left hand as shown and place
the filled bobbin inside.
3. Now pull the thread under the tension spring and into the
thread eyelet.
To insert the bobbin case and bobbin......
Ensure that about 15 cm (6 inches) of thread extends
out of bobbin. Hold the bobbin case so that long
finger on case points up. Open the latch of bobbin
case. Slip the bobbin case over the center pin of
hook and press in place until the long finger of the
bobbin case enters the notch entirely to lock the
bobbin in place. Release latch and press it down.
WINDING THE BOBBIN
1. Draw thread from spool through
bobbin winder tension disc as shown.
2. Pull end of thread through hole in bobbin
as shown.
3. Push bobbin winder shaft to far left position,
if it is not already there. Place bobbin onto
shaft with end of thread coming from top of
bobbin. Push bobbin winder shaft to right
until it clicks. Hold onto end of thread.
4. Start machine. The thread that is held will
snap or may be trimmed with a scissors,
Bobbin will cease turning when completely
filled. Push shaft to left to remove bobbin.
9
English
bobbin case
bobbin
slot
tension spring
eyelet
latch
long finger
notch
latch
When the bobbin winding is incorrect, release
the screw of the upper thread guide and adjust
the thread guide up or down until the winding
of the bobbin is balanced.