Filter
Top Products
9 of 14
888-24-205-G-03 rev. E • 12/12
12
1
2
ENGLISH
Remove the 4 brake stop screws before installing equipment.
Remove the 2 stop screws from the legs then the 2 stop screws from
the brake to allow the worksurface to raise and lower.
After you remove the 4 brake stop
screws, release the hand brake
(on the right leg) and move the
worksurface up to highest level.
Set-up Steps
IMPORTANT!
Save these stop screws and instructions. Install stop
screws when shipping or storing this product. Failure
to follow these instructions may cause lift engine to
expand rapidly and may result in equipment damage
and or personal injury.