Ergotron 24271926 Indoor Furnishings User Manual


 
3 of 14
888-24-205-G-03 rev. E • 12/12
1
2
3
4
ENGLISH
WARNING! TIPPING HAZARD!
When mounting accessories to the
WorkFit-D, they must stay within the foot
print. Do not mount accessories past the
front and rear worksurface! Failure to fol-
low this warning may result in equipment
damage and or personal injury.
WARNING! Stop screws are pre-installed in this product to secure it in the compressed position
during shipping and installation. DO NOT REMOVE THESE SCREWS UNTIL INSTRUCTED TO DO SO
IN THESE INSTRUCTIONS. Make sure these screws are in place before starting installation. Failure
to follow these instructions may cause lift engine to expand rapidly and may result in equipment
damage and or personal injury. If any of the 4 phillips head stop screws are not installed in these
locations, contact customer care before continuing with installation.
DO NOT REMOVE SCREWS!
DO NOT REMOVE SCREWS!
IMPORTANT!
Save these stop screws and instructions. Install stop screws when shipping or storing this product.
Failure to follow these instructions may cause lift engine to expand rapidly and may result in
equipment damage and or personal injury.
WARNING
Keep Brake Cables Away from
Sync Rod and Crossbars
During Installation!
Failure to keep the brake cables away from
sync rod and crossbars may restrict lift
motion and may cause equipment damage
or personal injury! Refer to instruction
manual for more information.