Filter
Top Products
7 of 14
888-24-205-G-03 rev. E • 12/12
3x
3x
M2.9 x 8 mm
2x
8
9
ENGLISH
Capture the brake cable in the cable clip as
illustrated, then use a Phillips screwdriver
to attach the cable clips to bottom of work
surface with the provided M2.9 x 8 mm screws.
Using the 2 provided cable ties, attach brake cable
to the legs leaving as much slack in cable as possible
between the cable tie and the leg to allow desk top to
raise up unrestricted. There should be equal lengths
of cable on each side.
NOTE: Leave as much
slack in cable as possible
between the cable tie and
the leg to allow desk top
to raise up unrestricted.
Failure to follow this
may result in equipment
damage.
Set-up Steps