Filter
Top Products
6 of 14
888-24-205-G-03 rev. E • 12/12
9x
16x
M5 x 6 mm
6
5
4
7
WARNING
Keep Brake Cables Away from
Sync Rod and Crossbars
During Installation!
Failure to keep the brake cables away from
sync rod and crossbars may restrict lift
motion and may cause equipment damage
or personal injury! Refer to instruction
manual for more information.
ENGLISH
Use a Phillips screwdriver to insert the provided M5x6
mm screws into the two crossbars connecting the left
and right legs. Make sure the brake cables don’t
loop around the crossbars.
Tighten the screws slightly one at a time
and repeat to ensure that the tension
on every screw is equal.
Partially insert 9 of the provided #12-14 wood screws
in the left leg and worksurface.
Set the left leg (without
hand brake) upright on the
worksurface.
Attach the left end of the
sync rod to the left leg.
Make sure the brake cables
don’t loop around the sync
rod. See Warning, right.
Use a Phillips screwdriver to tighten
down the screws attaching the legs to
the worksurface.
NOTE: Do not overtighten screws.
overtightening screws may result in stripping
the holes and may cause the installation to be
unsafe.
NOTE: Do not overtighten screws. overtightening
screws may result in stripping the holes and may
cause the installation to be unsafe.
NOTE: Do not
fully insert
the screws
into the work-
surface at this
time. Leave
approximate-
ly 1/8” space.
Set-up Steps
Front =2 screws
Middle = 3 screws
Rear = 3 screws
# 12-14 Wood Screw